Virtualization Technical Support for IBM i -v1 Set 4

An administrator is setting up IBM i in Partition 2 of a POWER Blade, in blade slot 9 of a BladeCenter H. What is used to access the IBM i console during the initial setup of a client IBM i partition?

While creating a new partition and choosing appropriate I/O resources, nothing appears on the Tagged I/O screen to be selected as a Load Source. Which of the following could cause this to happen?

There are three Power Systems servers with redundant FSPs, and two HMCs. One HMC is in the data center while the second is in operations. Each HMC is connected to its own private network and each of the three systems are connected to both HMCs. Two of the Power Systems servers and the HMC in the data center have been moved across the room. They have been reconnected to the HMC network, and power has been applied to the HMC and the first server. On the data center HMC the server shows up twice, once with Authentication failed and the second with no connection. Connecting to ASM yields incorrect password on the first instance, but works on the second instance. What the most likely cause?

A customer has a POWER6 520, with a 4-port Host Ethernet Adapter being shared by two partitions. The customer is migrating to a 6-core Power 720. One partition will need one 100Mb port to connect to an older Ethernet switch. The customer wants both partitions to run independently from one another, and provide redundancy at the adapter level What is the minimum necessary to support this requirement?

What is the correct method to install a firmware update on a single-image system?

What type of server and client adapters must be configured on the HMC to support virtualized disk presented from a V7000 SAN to an IBM i client partition?