×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
A POWER7 system has 6 IBM i partitions sharing a single shared processor pool. The system has 3 IBM i operating system licenses. Without exceeding the licenses available, what is the largest allowable value for the Maximum processing units setting in the shared processor pool?
2.
A customer has several client IBM i partitions, hosted by other IBM i partitions. Corporate IT policy specifies that certain optical and tape resources must not be available to client IBM i partitions. How can these resources be made unavailable to the client partitions?
3.
Which VIO Server command lets an administrator enter a non-restricted root shell to allow environment setup and installation of vendor software?
4.
A customer is implementing a new POWER7 system that will run along with an older POWER5 system. A new HMC has been purchased for the POWER7 system. The older 7310-CR3 HMC for the POWER5 system will remain in service. The customer wants the older 7310-CR3 provide back up to the new HMC. What must be done prior to implementing the customer's requirements?
5.
One partition on a multi-LPAR Power 720 has recently posted an error message about the upcoming expiration of a cache battery. How can all the other controllers on the partitions be checked to determine if they should have the same type of maintenance performed?
6.
Auditors have reviewed access to the HMC and determined that many users have too much authority on the HMC. What is the correct method to restrict users to only a specific set of resources?
7.
A client plans to add a Power 770 server to a POWEP6 environment. What resource can the administrator use to determine if the HMC is at the correct level to support the new server firmware?
8.
A hosted IBM i partition with SAN-based disk is to be configured with mirrored disks. In order to maximize performance of the partition, where should the disk mirroring be performed?
9.
What are two methods to determine the partition to which virtual disks are assigned?
10.
An administrator created a VIO Server partition in the System Planning Tool (SPT) and wants to pair the dual disk controllers for the partition. What is the correct process?