×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
Symantec Messaging Gateway 10.0 will be deployed to receive mail directly from the Internet. In this situation, which option should be selected within the Inbound Mail Filtering - Accepted Hosts step of the site setup wizard?
2.
The Symantec Messaging Gateway 10.0 appliance will be deployed with the following topology:
Internet Default Gateway (10.10.10.1) <--> Email Gateway (10.10.10.11) <--> Symantec Messaging Gateway
(10.10.10.21) <--> Internal Mail Server (10.10.10.31) Which IP address should be specified in the Mail Filtering
- Non-local Mail Delivery page of the site setup wizard?
(10.10.10.21) <--> Internal Mail Server (10.10.10.31) Which IP address should be specified in the Mail Filtering
3.
During the installation and configuration process, when will Symantec Messaging Gateway 10.0 require access to the network?
4.
What is required before attempting installation of the Symantec Messaging Gateway 10.0 appliance?
5.
Which TCP port is used for communication between the Control Center and the scanner(s)?
6.
There is a firewall in place between Symantec Messaging Gateway 10.0 and the Internet at the customer site. An administrator needs to use an external NTP server on the Internet for time synchronization. Which port must be open on the firewall to allow this?
7.
Before performing a software update on a scanner-only appliance, which MTA operation/mode should be chosen if there are messages in the queues?
8.
A diagnostics package for a scanner-only appliance can be generated from the GUI in Symantec Messaging Gateway 10.0. If the package is small (less than 5 MB), which transfer protocol type should be used by the administrator to verify the diagnostics package before providing it to technical support for analysis?
9.
Where are options for backup and restore of Symantec Messaging Gateway 10.0 located?
10.
What should an administrator do before performing a software update of Symantec Messaging Gateway 10.0?