Riverbed Certified Solutions Professional - Network Performance Management Set 5

The top applications for the previous week. Only the IPs that a user is authorized to see. Bandwidth for a host group over the previous day. Bandwidth for interfaces from devices NOT sending flow data. Connections for interfaces from devices sending flow data.

Rebalance moves flows among analysers in a Cascade Enterprise Profiler. Reallocate varies the storage space dedicated for templates and saved reports. Rebalance optimizes the use of the allocated space that allows you to get a longer retention time out ofthe same amount of disk space. Reallocate allows the users to decide the percent of total disk storage capacity that is allocated to thevarious flow logs. Rebalancing and Reallocating must be done simultaneously.

Number of connections per second Average response time TCP resets TCP retransmission Number of jumbo frames

Connect a capture port to a Port mirroring monitor port (also referred to as a SPAN port). Connect two capture ports to a passive network tap on a live link. One capture port is used for eachdirection of the link. Use the built-in AirCard capture port to capture traffic from a wireless network. Connect two capture ports across a link connected to a SPAN port already being used for packetcapture to another type of monitoring device and place Cascade Shark in "passthru" mode. Send sFlow with sampled packets to a Cascade Shark Capture port which has been placed in sFlowcollection mode.

192.168.0.100/255.255.0.255 Philadelphia 192/8 Baltimore 172.168.1.1 Phoenix 10/16 Chicago

1 ✘ 2 ✘ 3 ✘ 4 ✔ Unlimited ✔

The license key is entered during installation. The license is activated either through an Internet connection or by phone. ✘ The license key is entered during installation. The license must be activated through an Internetconnection. ✘ The license key is entered during installation. There is no activation but Cascade Pilot will detect if thelicense is already in use on the network. ✘ There is no license key activation. The software image is shipped with the license key installed. ✔

Connect a cross-over cable from your laptop to the Ethernet management port and connect through the
Web browser to the default IP Address of 192.168.1.10. ✘ Connect a cross-over cable from your laptop to the Auxiliary Ethernet port and connect through the Webbrowser to the default IP Address of 192.168.1.10. ✘ Connect by KVM or Serial Console and run the command line tool, sa_wizard, to perform the initialconfiguration. ✘ Connect to the appliance using the Riverbed Central Management Console (CMC) on its default IPAddress and perform the initial configuration. ✔

Can only capture traffic from a single port. ✘ Can only capture traffic that is routed (not switched) ✘ Can only capture traffic that is ingress or received by the device ✘ The number that can be configured is oftentimes limited to two ✔ Requires at least two monitoring ports to capture a single link ✔

1 ✘ 2 ✘ 5 ✘ 8 ✔ 10 ✔