×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
You have connected a new printer at a fixed IP address.
It appears to work correctly most of the time, but at other times does not respond
You suspect that the assigned address may not be unique within the network.
What command will be useful to confirm this?
It appears to work correctly most of the time, but at other times does not respond
You suspect that the assigned address may not be unique within the network.
What command will be useful to confirm this?
2.
Your server has a ZFS storage pool that is configured as follows:
The server has two spate 140-GB disk drives: c3t5d0 c3t6d0
Which command would add redundancy to the pool1 storage pool?
The server has two spate 140-GB disk drives: c3t5d0 c3t6d0
Which command would add redundancy to the pool1 storage pool?
3.
A user on the system has started a process, but it needs to be terminated.
The process ID was determined as follows:
pgrep userprogram
l5317
The user attempted to terminate the program as follows:
pkill 15317
This command runs without an error message, and the process continues to run.
What is the issue?
The process ID was determined as follows:
pgrep userprogram
l5317
The user attempted to terminate the program as follows:
pkill 15317
This command runs without an error message, and the process continues to run.
What is the issue?
4.
You are logged in to a Solaris 11 system as user jack. You issue the following sequence of commands:
Identify two correct statements.
Identify two correct statements.
5.
Which two are user definable OpenBoot parameters that can be set in the OpenBoot PROM?
6.
Which two capabilities are provided by the OpenBoot PROM?
7.
On which is the open boot prom available?
8.
Review the storage pool information:
Which statement describes the status of this storage pool?
Which statement describes the status of this storage pool?
9.
Which two statements describe the COMSTAR framework available in Oracle Solaris 11?
10.
You are troubleshooting interface net3 and you enter the following sequence of commands:
Your next command should be:
Your next command should be: