Oracle Solaris 11 Advanced System Administration Set 2

1.

The default route for the NCP static is changed with the following command sequence:
When does the entered route take effect?

after the set command after the verify command after the commit command after the exit command after enabling the location user (command not shown)

2.

How do you add a test address to an IPMP group?

Use ipadm create-addr to add the address to a member interface. Use ipadm create-addr to add the address to the IPMP interface. Use ipadm create-ip to add an address to a member interface. Use ipadm create-ip to add an address to the IPMP interface.

3.

Which two statements correct regarding Link Aggregations?

The MAC address of the first configured link is used for all links. A link with an existing IP interface cannot be added to an aggregation. The switch must support the Link Aggregation Control Protocol (LACP). Links of differing bit rates can be aggregated, but performance gains may not be realized. The f option of dladm allows aggregating devices that do not support link state notification.

4.

Which ipmpstat mode reports each link's status in an IPMP group?

address group interface probe target

5.

You are about to configure an AI server and you need to determine if NWAM is configured, if the system
has a manually configured IP interface. Which command gives you this information?

nscfg list netadm list netcfg list svcs network/physical

6.

You want to configure an anonymous IPMP group.
Which method lets you enable this behavior?

Set the config/transitive-probing property to true in the svc:/network/imp:default service.

Use the ipadm set-ifprop command to set the anonymous property to true for the IPMP interface.

Edit the /etc/default./mpathd file and set TRACK_INTERFACES_ONLY_WITH GROUPS=no.

Set the config/anonymous property to true in the svc:/network/ipmp:default service.

7.

Which two conditions must exist in order to add a new link to an aggregation?

The new link appears in the output of dladm show-phys. The new link may already support an active interface. The LACP policy must be set to L4. The link may currently be in any state. The new link has the same MAC address as the existing links.

8.

Examine the following command: ipadm create-addr -T static -a 192.168.1.112/26 net0/v6 Which two statements are true?

The interface is plumbed. The interface is marked down. The netmask value is ffffffc0. The link local IPv6 address fe80::112 is created. Multicast datagrams are not enabled on this interface.

9.

You added an interface to the IPMP group ipmp0 with the following commands:
# ipadm create-ip net4
# ipadm add-ipmp i net4 ipmp0
Which statement regarding the newly added interface is correct?

Link state failure detection will not occur. Probe-based failure detection will not occur. Without a data IP address, it cannot become active. These changes will be lost when the system is booted.

10.

Examine the following information:
Which statement describes the user auuser audit mask?

All failed and successful lo events, all failed and successful am events will be logged, no ss events will
be logged. All failed and successful lo events, all failed and successful am events and successful ss events will belogged. All failed and successful lo events, all failed and successful am events and failed ss events will belogged. All failed and successful lo events and all failed and successful ss events will be logged.

Oracle Solaris 11 Advanced System Administration Set 2

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Congratulations

COMPANY

Products

OTHERS

Partner

Oracle Solaris 11 Advanced System Administration Set 2

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Congratulations

Detail Form

COMPANY

Products

OTHERS

Partner