Oracle Exadata Database Machine Models X3-2 and X3-8 Implementation Essentials

1.

While planning for the installation of a SPARC M5-32 server, you notice that a more recent version of a patch is available than what is currently on the EIS-DVD.
According to the Enterprise Installation Standard (EIS) methodology, what should you do?

Always install the most recent version of patch. Delay installation until the updated patch is published to the EIS-DVD. Do not install the patch unless instructed to do so by an EIS Alert. Never install patches outside of the EIS- DVD.

2.

Before you can configure the service processors, which three pieces of information do you need from the customer?

SP0 IP address SP1 IP address domain IP address Active SP IP address clock board IP address

3.

Which three components require IP addresses when you configure the SP network?

SPO SP1 ACTIVE_SP SPARE_ SP SLAVE_SP

4.

Which component is a building block of physical domains (PDomainsorPDoms)?

CMU SPP IOU DCU

5.

You have used ILOM on other servers before, but notice that there are two targets that are new to ILOM on the SPARC M5-32 server. Which are they?

/System /Storage /Servers /SYS /sp

6.

Which three statements are true about PCIecard population on the SPARC M5-32 server?

Each DCU has two sets of PCIe slots. PCIe slots 1-8 are connected to IOB0, and PCIe slots 9-16 are connected to IOB1. The order of PCIe card portion is the same in the OCU with 2x or 4x CMUs. In a 4x CMU environment, PCIe slot 3 shares the same PCIe switch with the EMS (Base I/O board); the same is true for PCIe slots 6,11, and 14. In 2x CMU environments, PICe slots 3 and 4 share the same PCIe switch with the EMS I/O board); the same is true for PICe slots 5 and 6, PCIe slots 11 and 12,and PCI slots 13 and 14. In the DCU with 2x CMUs (in slots 0 and 3), you may only populated card to PCIe slots 1-8.

7.

You are performing some of the initial Service Processor (SP) login steps. How do you verify that you are on the Active SP?

Enter > show /SP/redundancy status where the result is "status = In progress".

Enter > show /sp/redundancy status where the result is "status = Active",

Enter > show /sp/redundancy status where the result is "status = Go",

Enter > show /SP/redundancy status where the result is "status = Ready".

8.

You run the following command: -> sec /HOSTO/bootmode script="setenv auto-boot? False" You notice on subsequent resets that Solaris boots in the domain. What are three possible reasons for this?

This is a one-time setting. The default setting for auto-boot? is True. Keyswitch is set to Normal. auto-boot? returns to its default setting at the next reset. Keyswitch is set to Locked.

9.

Which statement is true about LDom functions and features?

Each domain operates like an independent server that has full hardware isolation from the others. Each domain is a virtualized environment with a reconfigurable subset of hardware resources and an OS that can be started, stopped, and rebootedindependently. LDoms enable you to isolate one application from others on the same OS, allowing you to create an isolated environment in which users can log in and do whatthey want from inside this environment without affecting others. A maximum of 128 domains can exist on each SPARC M5-32 s

10.

There are a total of 36 fan modules in the SPARC M5-32 server, and all are redundant and hot- swappable. Which statement is correct?

Half of the 36x fan modules are located on the front and the other half on the rear. 18x fan modules are in front fan cages and 18x fan modules are in back fan

cages. 36x fan modules are located on the front and rear; 12x fan modules are in front fan cages, 12x fan modules are in back middle fan cages, and 12x fan modulesare in back lower fan cages. All 36x fan modules are located on the front, 16x fan modules in upper fan cages, 16xfanmodules in lower fan cages, and 2x fan modules on each side (left and right next to the SP/SSB). All 36x fan modules are located on the front, 12x fan modules are In upper fan cages, 12x fan modules are in middle fan cages, and 12x fan modules are inlower fan cages.

Oracle Exadata Database Machine Models X3-2 and X3-8 Implementation Essentials

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Congratulations

COMPANY

Products

OTHERS

Partner

Oracle Exadata Database Machine Models X3-2 and X3-8 Implementation Essentials

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Congratulations

Detail Form

COMPANY

Products

OTHERS

Partner