Network Appliance NetApp Certified Implementation Engineer - SAN, Clustered Data ONTAP (2) Set 1

You are planning a migration from a 7-mode system running Data ONTAP 7.3 to a new AFF A700 ONTAP 9.1 system. This 7-mode system provides only FC LUNs for a Windows Server 2012R2 server farm. The 7-Mode system cannot upgrade its volumes to 64-bit. In this scenario, what would you use for the migration?

Where would you find the environment values of controllers and disk shelves (e.g. BTU and watts)?

Where do you identify the disk shelves and disks that are supported for a specific controller model?

According to NetApp best practices, which method should be used for zoning?

You have a switch called "NK5-A". The switch is configured with an NP_Port. Which switch feature on NK5-A uses NP_Ports to allow for fabric expansion of new FC switches without having to designate additional domain IDs?

When a new LUN is allocated, which volume and LUN configuration will use the smallest amount of storage?

You need to perform a DR test on a FAS8200 with SAN LUNs using the onboard UTA2 with 16Gb SFP+. In this scenario, what is the minimum port speed required on the DR Site's FC switches?

You are performing storage failover testing on a 2-node FAS2650 cluster named cl01. A Windows Server 2012R2 host has 10 FC LUNs mapped from the cluster. After Cl01-01 takes over Cl01-02, the windows host loses access to all of its LUNs. Which statement describes what is happening in this scenario?

You have an iSCSI host that is unable to connect to an SVM named svm1 over a LIF name lif1. The home node and port of lif1 is port e0e. The event log show command displays the error iSCSI: network interface disabled for use; incoming connection discarded. Which command would you use to resolve the problem?

A new server has been installed in your environment, but it is unable to see its NetApp boot LUN. You have narrowed the problem down to the zoning on your Cisco switch which has the following configuration:
zone name z_NetAppvsan 400
memberpwwn 20:00:00:25: B5: C0:ff:ee
memberpwwn 50:0a:09:84:8d:7c:51: D5
zoneset name zs_NetAppvsan 400
memberz_NetApp
zoneset activate name zs_NetAppvsan 400
What is the problem with your zoning configuration?