Network Appliance Certified Storage Installation Engineer ONTAP

You completed the installation of an AFF A700s with NetApp CN1610 switches. You used ports e0a and e0f with breakout cables to connect the controllers to the interconnect switches. After completing the cluster setup, ports e0e and e0i are not visible in OnCommand System Manager. In this scenario, what caused this problem?

A 4-node cluster has connectivity for both block and file access. Nodes 1 and 3 are used for file access, and nodes 2 and 4 are used for block access. During routine maintenance, node 4 is switched off and the LIFs are migrated to other nodes. Upon investigation, you see that the LIFs that serve file traffic have moved to alternative ports. However, LIFs that serve the block have not migrated. In this scenario, what is happening?

A customer has a 6-node AFF A700 cluster and wants to add four nodes without having to update license functionality for each node manually. In this scenario, which type of license provides this functionality?

You are cabling two Cisco 3232C switches for the cluster interconnect of a 4-node AFF A800 cluster. Which pair of ports are used to cable the Inter-Switch Link (ISL) between the switches?

Which NetApp tool should you use to set up an ONTAP 9.5 cluster?

Which keyboard combination enables you to access the Service Processor (SP) or the Board Management Control (BMC) from the system console CLI?

You are installing a new 2-node AFF A220 cluster running ONTAP 9.5. The customer would like to use the UTA2 adapters from the first controller to connect to the 10GbE front-end switches. On the second controller, they would like to use the first UTA2 port as a target FC port, and the second as an FC initiator. In this scenario, according to NetApp Best practices, what should your customer do?

You were asked to install a FAS9000 with two quad-port SAS PCI cards. The SAS PCI cards are installed in slot 9 and slot 1. In preparation for the installation, you are filling out the SAS cabling worksheet. In this scenario, which ports are used for the second stack?

You are deploying a cluster with four AFF A300 nodes and Cisco 3232C switches. When you arrive at the customer's site, you notice that there are multiple breakout cables and four Cisco 3232C switches. In this scenario, which statement is true?

Which statement about LIFs is true?