×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
Which bit of SSPCON must be necessarily set so as to enable the synchronization of serial port?
2.
Which bits assist in determining the I2C bit rate during the initialization process of MSSP module in I2C mode?
3.
Which command/s should be essentially written for I2C input threshold selection and slew rate control operations?
4.
Where does the baud rate generation occur and begins to count the bits required to get transmitted, after an execution (set) of BF flag?
5.
How many upper bits of SSPSR are comparable to the address located in SSPADD especially after the shifting of 8 bits into SSPSR under the execution of START condition?
6.
Where should the value of TX9 bit be loaded during the 9 bit transmission in an asynchronous mode?
7.
Why is the flag bit TXIF tested or examined in the PIR1 register after shifting all the data bits during the initialization process of USART in asynchronous mode?
8.
What is the purpose of a special function register SPBRG in USART?
9.
How is the baud rate specified for high-speed (BRGH = 1) operation in an asynchronous mode?
10.
Which bit plays a salient role in defining the master or slave mode in TXSTA register especially in synchronous mode?