1.
Whenever you connect a Layer 2 switch to the xe-0/0/0 interface of the LC2 Node device in the server Node group of a QFabric system, the interface xe-0/0/0 on LC2 is disabled. What is causing this problem?
2.
Which service in a QFabric system provides the Junos CLI?
3.
What is the function of a Node device in a QFabric system?
4.
Which Node device design ensures a one-to-one subscription ratio?
5.
You want to change the device mode of a QFX3500 to connect to a QFabric system. Which command would you use?
6.
What is the function of a Director device in a QFabric system?
7.
An administrator of a QFabric system needs to know if LLDP is sent out to a neighbor. Which command should you use from a Node device?
8.
What is the number of Node devices supported in a network Node group?
9.
You are configuring a Node group name. Which statement is correct?
10.
The Node device LC0 is receiving packets destined to the host on the Node device LC1. The source IP address of the packets is 20.0.0.1 and the destination IP address is 77.0.0.1. How do you verify that the route to destination 77.0.0.1 exists in the RPDf table on LC0?