1.
What must be configured differently for a route-based VPN and a policy-based VPN?
2.
Which of the following protocols is required in order to deploy AutoConnect-VPNs?
3.
Which item in a virtual system is shared by default?
4.
When enabling RIP over a hub and spoke VPN, what must you configure on the hub device tunnel interface to allow spokes to receive routing updates?
5.
Which description about an Active/Active configuration is accurate?
6.
What is the maximum number of DSCP bits that can be configured for rewrite by a ScreenOS device?
7.
When using NSRP, which command will insure uninterrupted communications for VPNs using certificates for authentication?
8.
You have four policies configured for the egress interface with 10 Mbps physical bandwidth. The policies are configured as follows:
Policy 1 - Highest Priority, 2 Mbps guaranteed, 3 Mbps maximum
Policy 2 - 1st Priority, 3 Mbps guaranteed, 4 Mbps maximum
Policy 3 - 1st Priority, 3 Mbps guaranteed, 3 Mbps maximum
Policy 4 - Highest Priority, 1 Mbps guaranteed, 4 Mbps maximum
Assuming the policies are processed in the order shown, which policy will drop traffic first under a full traffic load?
9.
You create a policy-based VPN, and select an address group for the source address. What will be the source component of the proxy-id seen by the remote security gateway?
10.
You are concerned about log entries being overwritten and would like to save this valuable information on an external system. Which three systems will work with ScreenOS devices to accomplish this goal? (Choose three.)