1.
Which command shows the filter applied to snoop captures?
2.
When enabling OSPF over a hub and spoke VPN, what must you configure on the hub device tunnel interface to allow spokes to receive routing updates?

 
3.
What do you need to change in your IPSec VPN configuration to use certificates for authentication?
4.
You have enabled RIP in a hub and spoke VPN environment, using demand circuits. You are not receiving routes from one of your spokes, although the VPN is up. When you debug RIP on the spoke device, you see regular RIP updates being generated on the tunnel interface. You are receiving and sending routes to the rest of your spokes. What is the problem?
5.
You have configured NSRP Active/Passive using the default vsd-group. You are using BGP to learn routes from adjacent network devices. You want each firewall to establish a BGP peer to different upstream routers. You also want the backup device to learn dynamic routes. Which configuration would ensure you can establish a BGP peer to two different routers?
6.
You are a read/write VSYS administrator. Your configuration requires the use of a MIP. Which statement correctly describes this situation?
7.
Which command is used to verify that IGMP is running correctly?
8.
You create three policies that will send traffic through an interface configured for 1.544 Mbps. All policies are
configured to have 256 Kbps guaranteed bandwidth and 512 Kbps of maximum
bandwidth. Each policy has been assigned the following priorities:
Policy 1 = priority 4
Policy 2 = priority 5
Policy 3 = priority 3
Each policy receives a constant stream of 1 Mbps.
How much bandwidth will be available for Policy 2?
9.
When adding deep inspection to a policy, when will inspection be performed?
10.
What should you configure to insure an HA cable failure does not result in both devices attempting to become master?