1.
You have entered the following OSPF configuration:
set vrouter trust-vr protocol ospf
set vrouter trust-vr protocol ospf area 10
set interface e0/0 protocol ospf area 10
set interface e0/0 protocol ospf enable
set interface e0/1 protocol ospf area 10
set interface e0/1 protocol ospf enable
OSPF is not working. What is missing from your configuration?
2.
You are concerned that one of the routes on your ScreenOS device has been flapping. You would like to investigate how long this route has been up and when the last outage occurred. Which command will provide you with this specific information?
3.
You have created a virtual router called VSYSA-vr and made it shareable. You then create the VSYS using the WebUI, telling it to use an existing VR and selecting the VR called VSYSA-vr. What is the status of the virtual router after you create the VSYS?
4.
Which ScreenOS CLI command would be used for importing routes from the untrust-vr to OSPF in the trust-vr?
5.
What will happen if you type the command unset protocol vrouter trust-vr protocol ospf?
6.
You create three policies that will send traffic through an interface configured for 1.544 Mbps. All policies are configured to have 256 Kbps guaranteed bandwidth and 512 Kbps of maximum bandwidth. Each policy has been assigned the following priorities:
Policy 1 = priority 4
Policy 2 = priority 5
Policy 3 = priority 3
Each policy receives a constant stream of 1 Mbps.
How much bandwidth will be available for Policy 2?
7.
During main mode negations a failure has occurred while using IKE certificates. Which message pair would you review to troubleshoot this failure?
8.
When using NSRP, which command will insure uninterrupted communications for VPNs using certificates for authentication?
9.
If you configure 5 Mbps of guaranteed bandwidth for a policy, and you have 10 sessions created for that policy, how much bandwidth is reserved for each session?
10.
Which statement defines maximum bandwidth?