1.
You have set the OSPF reference bandwidth to 1 Gigabit. Which statement is true?
2.
Which statement is correct regarding policer use for CoS in the enterprise?
3.
Your Juniper WAN router is connected to an Ethernet switch that is configured to use 802.1p bits for classifying traffic. Which statement is correct about the configuration of CoS on the router?
4.
What is the primary reason to configure CoS for branch office connectivity?
5.
What is the primary reason for configuring a multi area OSPF network?
6.
Which statement is true for a DTE frame-relay interface on a Juniper Networks router?
7.
You are an ISP. Your backbone IP address space is 10.10.0.0/16. Your network management IP address space is 192.168.100.0/24. A firewall filter is applied to lo0 which allows management access using Telnet and FTP. Which firewall filter will also allow OSPF and BGP to function without blocking management access ?
8.
You are using the route redistribution strategy to transition your network from RIP to OSPF. What must you do to avoid routing loops?
9.
BGP communities can be used to influence your ingress traffic from the Internet. The communities signal the ISP to change specific route attributes for this purpose. Which two attributes should be used for this? (Choose two.)
10.
You are examining the output of the stateful firewall session table. Which state indicates that the router is using an application-layer gateway (ALG) to forward traffic?