Juniper Networks Certified Internet Associate (JNCIA-WX)

1.

Which feature must be enabled to use Packet Flow Acceleration?

application monitoring WebView Application Flow Acceleration quality of service

2.

Why is SNMPv2 used to monitor the WX platform?

SNMPv2 supports both 32- and 64-bit counters. SNMPv2 does put and get commands to WX devices. SNMPv1 is not supported by WX devices. SNMPv1 is read-only on WX devices.

3.

Which Packet Flow Acceleration feature performs TCP acceleration?

Network Sequence Caching forward error correction Application Flow Acceleration Active Flow Pipelining

4.

What is NSC's functionality?

TCP acceleration sequence caching next-generation compression Web caching

5.

What is MSR's functionality?

disk-based reduction memory-based reduction application acceleration sequence caching

6.

Which action occurs when a WX device is configured for the hub-and-spoke topology?

The meshed devices send memory allocation parameters to the spoke devices. The reduction setting of "Only checked WX devices below" cannot be checked. All spoke devices default to the reduction setting of "Only WX devices designated as hubs". Spoke-to-spoke communications are no longer available.

7.

Which statement about the WebView submit command is true?

The submit command exits the GUI. The submit command is the same as the commit CLI command. The submit command reboots the WX device. The submit command saves and writes the configuration to flash.

8.

What are two ways to verify if a WX device is configured as a hub, a spoke or a mesh device? (Choose two.)

Reduction > Endpoints Setup > Advanced > Features/Topology Admin > Device Setup > Features/Topology

9.

Microsoft's file sharing, Microsoft's e-mail, and Web browsing is performed in Customer A's network. Customer B uses its network for only Citrix traffic. Which two solutions satisfy both customers? (Choose two.)

PFA and AppFlow for Customer B PFA for Customer A PFA and AppFlow for Customer A PFA for Customer B

10.

How does a WX device use local routes to determine whether a reduction subnet is valid?

It checks whether the local route's gateway is on the LAN side. It checks whether the default gateway is on the WAN side. It checks whether the default gateway is on the LAN side. It checks whether the local route's gateway is on the WAN side.

Juniper Networks Certified Internet Associate (JNCIA-WX)

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Congratulations

COMPANY

Products

OTHERS

Partner

Juniper Networks Certified Internet Associate (JNCIA-WX)

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Congratulations

Detail Form

COMPANY

Products

OTHERS

Partner