1.
The monitor traffic command provides access to which utility?
2.
Which command would initiate a loopback on a Gigabit Ethernet interface ge-0/0/0?
3.
When a local loopback is activated on a PPP serial link, what indicates that the local interface is good?
4.
How is a loopback cleared on interface ge-0/0/0?
5.
Which CLI command is used to upgrade a Juniper router?
6.
When performing password recovery, which command should be entered at the boot prompt?
7.
In which routing table would you find an OSPF V2 route?
8.
By default, which routing table is used to store unicast IPv4 routes?
9.
Which type of routes are held in Inet.0?
10.
What is the role of route preference?