Juniper Networks Certified Internet Associate, FWV (JNCIA-FWV) Set 1

By default, from which hardware component is the startup copy of the ScreenOS loaded?

What is the default mode for an interface in the trust zone?

Which command is used to verify IKE Phase 1 is complete?

You are configuring an interface in the untrust zone with an IP address, telnet enabled, and WebUI management. Which sequence of steps must be performed to make the interface operational at the end of the configuration sequence?

Which ScreenOS CLI policy statement keyword would enable a policy only during specified times, days, and/or dates?

A ScreenOS firewall is running in transparent mode. The firewall receives a packet which has no entry in its forwarding table. What will the firewall do?

When adding an address book entry for a host, which mask should be used?

An operational firewall needs a configuration loaded and executed while it is passing user data. Which CLI command will perform this process without interrupting traffic?

Telnet management has been enabled on an interface in the untrust zone. What else should be completed to limit telnet access to the ScreenOS device from trusted management PCs?

Which ScreenOS CLI policy statement keyword would be used to enable traffic counters?