Juniper FXV, Associate (JNCIA-FWV) Set 2

They can be unnumbered and used in policy-based translations if the interface is in route mode ✘ They need to be configured in the zone where the protected resources reside ✘ They can be unnumbered from any interface residing on the same virtual router as the protected resources ✘ They can have overlapping IP addresses ✔

Schedule ✘ Calendar ✘ At ✘ Scheduler ✔

Once the "Config rollback" feature is enabled, it allows the administrator to re-apply a locked configuration file from a separate area in flash ✘ Once the "Config rollback" feature is enabled, it allows the administrator to re-apply a previously savedconfiguration file from the flash ✘ The "Config rollback" feature is enabled by default, it allows the administrator to re-reply a previously savedconfiguration file from flash ✘ Once the "Config rollback" feature is enabled, it allows the administrator to revert to the prior ScreenOSimage or configuration file in event an upgrade operation aborts ✔

Getmip ✘ Get session ✘ Get translation ✘ Getnat ✔

The policy is currently passing traffic beyond its traffic limits and is in alarm state ✘ The policy is currently inactive ✘ The policy is configured for unidirectional NAT ✘ The policy is configured to support a MIP ✔

You can apply the negate option to services ✘ You can only use theWebUI to configure multi-cell policies ✘ You can apply the negate option to a source address ✘ You can add up to 32 different addresses or services per cell ✔

The second packet causes an ARP query ✘ The second packet is checked against the policy table ✘ The second packet is forwarded without a sanity check ✘ The second packet is forwarded without checking the route table ✔

Transparent ✘ Layer 3 ✘ Layer 2 ✘ Nat ✔ Route ✔

Getike active ✘ Getsa a active ✘ Getike cookie ✘ Get flow active ✔

Set multiple service ✘ Set policy from trust tountrust any any permit ✘ Set service ✘ Set service multiple ✔