1.
You want to configure Layer 2 services over an IP-based tunneling mechanism between two sites. Which configuration statement is required to accomplish this task?
2.
Which statement is correct about trunk ports?
3.
You want to advertise only a default route into a new area, which will be called area 7. In this scenario, which configuration statement would solve this problem?
4.
Which static route next-hop value indicates that the packet will be silently dropped?
5.
Which area is reserved for the OSPF backbone?
6.
You want to configure your Junos device so that routing information from certain prefixes on a neighboring router are ignored. What should you configure on your device?
7.
Your network connections to the Internet through two different ISPs using EBGP. You must ensure that ISP1 is the primary path used for all traffic entering your network while using ISP2 as a backup path. In this scenario, which statement is correct?
8.
Which statement is true when using LAGs with an EX4300?
9.
How many bytes of overhead are added to a packet traversing a GRE tunnel?
10.
You added a new ESXi host connected to port ge-0/0/1. One of the VMs configured with VLAN 10 is not reachable from any other device on the switch. To troubleshoot, you decide to verify if the VM's MAC address is learned properly under VLAN 10. Which command would you use in this scenario?