×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
A resource group is configured with a startup policy of Online on First Available Node and a service IP address which uses IPAT via aliasing. An administrator needs a custom event to run only during a failover. Which pre-defined event would be best to specify the custom event?
2.
A customer has completed installing PowerHA 7 filesets. Which task, or tasks, should be completed next?
3.
An active, active (mutual takeover) 2-node PowerHA cluster is currently up and stable. Both nodes are located in separate buildings, one kilometer apart. Node2 in SiteB suddenly powers off. On
reboot of the failed node, the cluster administrator checks the error log and discovers the node had been halted. The network team confirms there was a temporary loss of the IP network between sites. Why did Node2 halt?
reboot of the failed node, the cluster administrator checks the error log and discovers the node had been halted. The network team confirms there was a temporary loss of the IP network between sites. Why did Node2 halt?
4.
What must be done before defining a pre-event command for a predefined cluster event?
5.
The database is running on node1 and application is running on node2. The application cannot run unless database is active and the application must be stopped before the database. What actions will ensure the application and database run correctly?
6.
An administrator performed a DARE operation in their cluster configuration. During this operation one of the cluster nodes halted. The node halt was an isolated problem, however, as a result the
DARE operation did not complete. When the failed node was re-integrated to the cluster, the following error was received when trying to perform the DARE operation again:
cldare: A lock for a Dynamic Reconfiguration event has been detected. Which action will resolve the problem?
DARE operation did not complete. When the failed node was re-integrated to the cluster, the following error was received when trying to perform the DARE operation again:
cldare: A lock for a Dynamic Reconfiguration event has been detected. Which action will resolve the problem?
7.
Given the following cluster topology information, why is this PowerHA 6 cluster configuration unsuitable for migration to PowerHA 7?
8.
An administrator is using PowerHA 7 to define a new cluster using SMIT option "Setup a Cluster, Nodes and Networks and encountered the following error message: What is the root cause of the problem?
9.
Which are names of default file collections in PowerHA 7?
10.
What are the two types of application monitors that can be created?