×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
What is the effect of the following command entered at the switch CLI? E3500(vlan-200)# no untag 22
2.
At a customer site, you have configured static link aggregation between an HP E8212 zl switch and an HP E5406 zl switch. The aggregated link includes two ports on each switch. During testing, traffic analysis reveals that only one of the links is being used to full capacity. The other link is operating well below capacity. What is an accurate explanation for this finding?
3.
Which command saves the running configuration of an HP E5400 zl Series switch to its startup configuration?
4.
To begin updating the software on this HP E-Series switch, an administrator issues the following command at the CLI: Switch(config)# copy usb flash K_14_65.swi secondary If the file transfer is successful, when will the switch begin using the K.14.65 software?
5.
What is the effect of the following command issued at the CLI of an HP E5400 zl Series switch? Switch# show logging 1
6.
What is the relationship between the primary and secondary flash areas of an HP E8206 zl switch?
7.
You must install an HP E-MSM AP that is at factory settings. When must you change the AP's operating mode?
8.
You must connect an E-MSM Access Point to a switch that supports the PoE (802.3af) standard. What is the maximum amount of power the AP will be able to receive from the switch?
9.
What is a Virtual Service Community (VSC)?
10.
You must configure an E-MSM Access Point that is configured for autonomous mode. Which management interface must you use for this task?