1.
Your customer wants to have the flexibility to allocate and unallocate storage as needed to efficiently use
their existing physical storage. Which feature of the Hitachi NAS Platform would you use?
2.
You are asked to install a Hitachi NAS Platform 3200 system at a customer site using brand new equipment
delivered from the distribution center. Which process will make certain that the node is operational after the
initial setup?
3.
Which Hitachi NAS Platform CLI command can assist you and provide suggestions for further
troubleshooting?
4.
Your customer plans to use jumbo frames when installing a Hitachi NAS Platform cluster into their existing
network infrastructure. What must be configured for this to work?
5.
You replaced an internal RAID-1 HDD on a Hitachi NAS Platform 3080/3090. Which action must you
complete?
6.
A customer with Fibre Channel (FC) host port redundancy has discovered a problem with one of two
interfaces on a node. The problem was caused by a faulty Fibre Channel cable. You are asked to replace
the cable and to make sure redundancy at the FC host port level is re- established. Which statement
describes what should be performed?
7.
What is a supported authentication mode for the Microsoft iSCSI Initiator when used with a Hitachi NAS
Platform?
8.
A customer has purchased two Hitachi NAS Platform systems to be used as an image repository for their 4
KB image files. The customer will replicate these files between two sites using their Metropolitan Area
Network (MAN). Which Hitachi NAS Platform replication feature would you use?
9.
A customer is upgrading network core switches and they have four 1 Gb Ethernet ports available on
different blades within the same switch. Which feature should you enable on the Hitachi NAS Platform?
10.
You are implementing a Hitachi NAS Platform solution for a customer using both CIFS and NFS. The
customer wants to use the Mixed (Windows and UNIX) ACL type on their file system and map users
between the two environments. User names are not common between the two environments and manual
user mapping is required. What information is necessary to create a manual mapping?