×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
This type of OSPF router has its router interfaces connected into multiple OSPF areas.
2.
Which CLI command would you use to configure the switch to ignore STP for selected VLANs?
3.
Which of the following CLI commands would you use to enable ECMP for RIP?
4.
If you wish to silently drop all traffic destined for IP network 100.219.10.0/24 with a gateway of 10.219.10.1/24 and without receiving any ICMP messages that would otherwise be generated, which CLI command would you execute?
5.
What is true when VLAN corporate shows a protocol field with the value of NONE.
6.
RIP is a routing protocol that scales to a limit. What is the maximum number of supported hop counts?
7.
In order to span multiple VLANs across Extreme switches, the protocol EDP must be enabled.
8.
What information will the CLI Command show edp provide?
9.
What is the maximum number of simultaneously active protocol filters in the switch for all based Extrem switch products?
10.
Which CLI command would you use to add a VLAN to a newly created STPD s1?