×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
Which command would you use to configure ESRP ping tracking for the gateway address 10.0.0.1 with a frequency of 2 seconds and a miss threshold of 5?
2.
Which of the following is the default ESRP hello timer setting?
3.
Which commands would you use to configure an ESRP domain with VLAN HQ as the super- ESRP-VLAN and VLAN floor-1 as the sub-ESRP-VLAN?
4.
Which of the following commands could you use to determine which ports are enabled for ESRP host attach?
5.
What effect does the hierarchical model of OSPF have on network traffic?
6.
A VLAN configured for routing can support only one physical port.
7.
OSPF area 20.20.20.20 connects to OSPF area 2.2.2.2. The network has been running for a week without issues. While examining the LSDB of an internal router in area 20.20.20.20, the network administrator sees that there are no Type-2 LSAs for area 2.2.2.2 listed. The network administrator asks your opinion about this. What do you say?
8.
OSPF area 0.0.0.0 is connected to area 1.1.1.1. Stub area 2.2.2.2 is connected to area 1.1.1.1. Area 2.2.2.2 routers show only directly connected networks in their
IP route tables. What must you do to resolve this situation?
9.
Which of the following are ways the IP route table becomes populated?
10.
Which of the following are ways the IP route table becomes populated?