CWNP-Certified Wireless Design Professional (CWDP)

Question - 29 Maximum mark : - 50

Home
All Exams
CWNP-Certified Wireless Design Professional (CWDP) Online Mock Tests
CWNP-Certified Wireless Design Professional (CWDP)

Which option on the Cisco Telepresence System administration WebGUI allows selecting table type?

Always use paints with metallic dye in them to prevent potential RF propagation impact. Do not paint the notification LEDs on the AP, but configure them to be dim or turned off altogether untiltroubleshooting is required. Painting APs may void the product manufacturer's warranty. Most AP models for indoor environments come in a variety of form factors and colors. Painting is neverrecommended. Painting APs always introduces a fire and gas emissions hazard and should be avoided for all indoorAPs.

Answer & Solution Discuss in Board Save for Later

Answer & Solution

Answer: Option B

Solution:

It provides fallback for IE8.

What is the first step when preparing to attach the Cisco Telepresence System 1100 or Cisco Telepresence System 1300 mounting bracket to the wall?

The sequence control field value ✘ The acknowledgement timeout threshold ✘ The minimum transmit data rate value ✘ The CTS-to-self threshold ✔ The Beacon interval ✔

Answer & Solution Discuss in Board Save for Later

Answer & Solution

Answer: Option B

Solution:

It provides fallback for IE8.

What is the default configuration for displaying presentations on a Cisco Telepresence System 1000?

All MAC functions are performed by the AP. A minimal subset of network control is offloaded to the
WLAN controller along with management and monitoring functions. ✘ PHY functions are performed directly by the AP. MAC functions are divided almost equally between theWLAN controller and the AP, according to the time sensitivity of the feature or service. ✘ The AP provides the RF termination point for the WLAN, but performs very few of the WLAN functionsor services. The WLAN controller performs all MAC functions and the AP is very simple and lightweight. ✘ All RF-, data-, and control-related WLAN functions are performed by the AP. APs coordinate networkservices with one another and are managed by a WNMS, so no WLAN controller is used in this
architecture. ✔

Answer & Solution Discuss in Board Save for Later

Answer & Solution

Answer: Option B

Solution:

It provides fallback for IE8.

Which statement is correct when discussing the microphone placement for the Cisco Telepresence System 1100?

IEEE 802.1Q PCP marks in the Ethernet frame header User Priority marks in the IEEE 802.11 frame header Throughput subscription marks in the Ethernet frame header MPLS tags from the Label Edge Router (LER) DSCP marks to the ToS bits in the encapsulating IP packet header

Answer & Solution Discuss in Board Save for Later

Answer & Solution

Answer: Option B

Solution:

It provides fallback for IE8.

A Cisco Telepresence System 1000 is being installed into a room where the walls are constructed of drywall over metal studs. What is the correct mounting hardware for this type of installation?

On-demand video streaming over wireless ✘ Data connection with frequent roaming ✘ Location-based services for wireless assets or RFID tags ✘ VoWLAN if the codec is G.729. ✔ FTP over implicit TLS/SSL ✔

Answer & Solution Discuss in Board Save for Later

Answer & Solution

Answer: Option B

Solution:

It provides fallback for IE8.

Which would be considered the best environment to house a dedicated Cisco TelePresence system?

In QoS WLANs, multicast traffic is always assigned to the best effort (AC_BE) transmit queue. ✘ Group addressed downlink frames are not acknowledged on the wireless medium. ✘ Multicast traffic must always be transmitted via omnidirectional antennas. ✘ Frames with a group receiver address must always be sent at a rate in the Basic Rate Set. ✔

Answer & Solution Discuss in Board Save for Later

Answer & Solution

Answer: Option B

Solution:

It provides fallback for IE8.

What are two Cisco recommendations when a customer has magnetic ballast installed in?

All VoWiFi implementations ✘ Push-to-Talk VoWiFi phones ✘ VoWiFi soft phones ✘ FMC phones ✔ Flat (non-VLAN) VoWiFi implementations ✔

Answer & Solution Discuss in Board Save for Later

Answer & Solution

Answer: Option B

Solution:

It provides fallback for IE8.

When booting the Cisco TelePresence 500, how do you determine which IP address is used by the codec before connecting to the codec via WebGUI?

Voice ✘ Email ✘ Skype chat ✘ Video-on-demand ✔ Video conferencing ✔

Answer & Solution Discuss in Board Save for Later

Answer & Solution

Answer: Option B

Solution:

It provides fallback for IE8.

When using the camera target on a Cisco TelePresence System 1300, how often do you need to repeat the auto-adjust procedure before all cameras are calibrated?

By disabling support for 1 and 2 Mbps while allowing 5.5 and 11 Mbps, the network will force 802.11b
clients to use these higher data rates. ✘ Protection mechanisms will always be in use on this network to support 5.5 and 11 Mbps as basic rates. ✘ HR/DSSS (802.11b) stations will not be able to associate to the service set. ✘ This configuration violates the IEEE specification that defines 6, 12, and 24 Mbps as mandatory datarates for 802.11g/n. ✔ MCS 0 will represent the lowest data rate that can be used in the service set. ✔

Answer & Solution Discuss in Board Save for Later

Answer & Solution

Answer: Option B

Solution:

It provides fallback for IE8.

10.

Which statement is correct when discussing the Cisco Telepresence System 500?

All WMM-PS certified client devices will be prevented from utilizing WMM-PS features until all stations in
use on the wireless medium are WMM-PS certified. ✘ The WLAN infrastructure will set the dozing times of the WMM-PS certified client devices based upontheir WMM access category, while the non-WMM-PS client devices will continue to use PS- Poll frames. ✘ Performance and battery life will be inconsistent between WMM-PS and non-WMM-PS client deviceswhen used with applications that support WMM-PS. ✘ WMM-PS enabled APs will allow both WMM-PS and non-WMM-PS stations to use the trigger- and-delivery mechanism, but WMM-PS stations will get priority. ✔ When all STAs are using Power Save features, WMM-PS STAs will experience poor performance dueto PS protection mechanisms. ✔

Answer & Solution Discuss in Board Save for Later

Answer & Solution

Answer: Option B

Solution:

It provides fallback for IE8.

Prev Next

Congratulations

you have successfully completed the test

Back to Question View Result

Detail Form

We will send your result on your email id and phone no. please fill detail

Name

Email ID Note: Report will be send to the above Email ID

Phone No

CWNP-Certified Wireless Design Professional (CWDP)

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Congratulations

COMPANY

Products

OTHERS

Partner