CWNP Certified Wireless Analysis Professional Set 1

Which statement about the Lightweight Access Point Protocol (LWAPP) is true?

LWAPP is meant to be a network protocol for access points that also provides for centralized management. Which issue or set of issues does the Lightweight Access Point Protocol (LWAPP) address?

Currently in draft status at the IETF, LWAPP outlines a standard protocol to be used by switches or routers to control a group of IEEE 802.11 wireless LAN access points and make their deployment much simpler than is possible today. Which statement about the Lightweight Access Point Protocol (LWAPP) protocol is true?

Which set of statements describes the correct order and process of a wireless client associating with a wireless access point?

Which protocol specified by RFC 2281 provides network redundancy for IP networks, ensuring that user traffic immediately and transparently recovers from first-hop failures in network edge devices or access circuits?

Which of the following HSRP router states does an active router enter when it is preempted by a higher priority router?

Three Cisco Catalyst switches have been configured with a first-hop redundancy protocol. While reviewing some show commands, debug output, and the syslog, you discover the following information:
What conclusion can you infer from this information?

You administer a network that uses two routers, R1 and R2, configured as an HSRP group to provide redundancy for the gateway. Router R1 is the active router and has been configured as follows:
Which of the following describes the effect the "standby preempt delay minimum 50" command will have on router R1?

Which first-hop redundancy solution listed would supply clients with MAC address 0000.0C07.AC0A for group 10 in response to an ARP request for a default gateway?

You want to allow Router R1 to immediately become the active router if its priority is highest than the active router fails. What command would you use if you wanted to configure this?