×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
What is the result of entering the command spanning-tree loopguard default?
2.
Examine the diagram. A network administrator has recently installed the above switched network using 3550s and would like to control the selection of the root bridge. Which switch should the administrator configure as the root bridge and which configuration command must the administrator enter to accomplish this?
3.
What must be the same to make multiple switches part of the same Multiple Spanning Tree (MST)?
4.
Which statement correctly describes the Cisco implementation of RSTP?
5.
The network administrator maps VLAN 10 through 20 to MST instance 2. How will this information be propagated to all appropriate switches?
6.
Which MST configuration statement is correct?
7.
While logged into a Company switch you issue the following command:
CompanySwitch(config-mst)#instance 10 vlan 11-12
What does this command accomplish?
CompanySwitch(config-mst)#instance 10 vlan 11-12
What does this command accomplish?
8.
By default, all VLANs will belong to which MST instance when using Multiple STP?
9.
What will occur when a nonedge switch port that is configured for Rapid Spanning Tree does not receive a BPDU from its neighbor for three consecutive hello time intervals?
10.
A port in a redundant topology is currently in the blocking state and is not receiving BPDUs. To ensure that this port does not erroneously transition to the forwarding state, which command should be configured to satisfy the requirement?