CompTIA-Server+ 2004 Set 4

Without bringing the server down, which of the following is the FIRST step in removing a NIC that is in a hot- plug PCI slot?

After a pre-installation walkthrough, the server technician concludes that the power outlets, rack dimensions, physical security, and network cabling are all acceptable. However, one factor is missing in the pre-installation planning, so the technician decides not to install the server in this location. Which factor was not included in the pre-installation planning?

During a new server installation, which of the following is the MOST common setup problem?

Which statement is true about symmetrical multi-processing?

A company has 260 clients and one server. The server appears to be compromised by a security hole. The operating system manufacturer has provided a security patch. Which two actions should be taken next? (Select TWO)

A company implements a new policy requiring that all data stored on the servers, regardless of their RAID level, be secured and locally accessible only to administrators. How does this affect the diagnostic partitions on the servers?

The current data center has run out of space. A room that is located next to the existing data center is then used to house two racks containing six servers. Six months later, physical housekeeping is performed as part of a mid-year maintenance plan. Which environmental condition discovered in the room is LEAST critical?

Which type of server is designed to serve as a gateway for communications between clients using C and a mainframe computer?

During the installation of a new server, the following actions are performed: Server hardware components are inventoried. The latest BIOS and firmware are downloaded and applied. The network operating system and patches are loaded. The after-market tape drive attached to the server fails to initialize. Which of the following is the MOST likely cause of the failure?

Replacing an existing controller with a newer controller that may have different PCI resource requirements (e.g. CHs, F/W) is an example of which type of hot plug technology?