×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
Which of the following cables has a hard plastic cross inside the cable to separate each pair of wires?
2.
Which of the following connectors is used on a coaxial cable?
3.
Frequency, channel bonding, and MIMO configuration are all characteristics of which of the following networking technologies?
4.
A small office needs to connect one new system to their network in a distant office, but does not have the resources to install a new Ethernet wall jack, and does not
want to use wireless. Which of the following is a simple, cost effective option for providing connectivity?
5.
Which of the following defines the pinout of an 8P8C eight pin modular jack for a CAT6a cable?
6.
Which of the following WAN technologies has a MAXIMUM speed of 155.52Mbps?
7.
A technician is troubleshooting a problem where data packets are being corrupted. Which of the following connectivity problems should the technician check?
8.
A technician is not getting a link light on two switches connected by a fiber cable. After the cable tests good, which of the following should the technician check
NEXT?
9.
Which of the following is a square shaped fiber connector that is slightly smaller than a standard copper network cable connector?
10.
Which of the following wiring distribution is used to connect wiring from equipment inside a company to carrier cabling outside a building?