1.
The main points of attack that can be compromised during authentication on a converged network are: (Select THREE)
2.
A technician is worried that email messages are being captured, modified and then resent to the intended recipients, while in transit. Which of the following can be MOST easily installed to detect and protect against this type of abuse?
3.
After creating three separate VLANs on LAN switches, the technician determines users cannot pass data traffic from one VLAN to another. Each VLAN can individually communicate with other users that are located in their own VLAN group. Which of the following must be done to solve this problem?
4.
Which of the following is a benefit of the 802.11a WLAN standard?
5.
A merged company has two digital voice messaging systems from different manufacturers. Which of the following standards would the combined company consider to network the multi-vendor messaging systems together?
6.
Voice quality issues are reported between two remote sites that are connected via an IPSec VPN. The technician believes that the service provider network may be the cause of voice quality issues, and asks the service provider for packet loss, jitter, and delay statistics of the voice calls. Which of the following makes it impossible for the service provider to meet this request?
7.
A telecommuter registering their softphone over an Internet VPN to the main sites IP PBX is complaining of one-way audio. The technician determines that Network Address Translation (NAT) is the cause of the issue. Which of the following should the technician consider to circumvent the NAT traversal issue?
8.
Which of the following elements of the SIP protocol defines the media type to be established?
9.
A technician enables voice and signaling encryption between a heavily used IP -PBX and the IP endpoints at a remote site. Afterwards, the technician receives complaints of fast-busy signals from users at the remote site when they go off-hook. Which of the following BEST explains the cause?
10.
The first message in SIP call setup is typically: