1.
Which statement about the use of PagP link aggregation on a Cisco switch that is running Cisco IOS Software is true?
2.
Which statement describes what happens when a port configured with root guard receives a superior BPDU?
3.
Which statement about restrictions for multichassis LACP is true?
4.
What is the maximum number of 10 Gigabit Ethernet connections that can be utilized in an EtherChannel for the virtual switch link?
5.
Which statement describes what happens if all VSL connections between the virtual switch members are lost?
6.
Which statement is correct about 802.1Q trunking?
7.
Which of the following commands can be issued without interfering with the operation of loop guard?
8.
The following command was issued on a router that is being configured as the active HSRP router.
standby ip 10.2.1.1
Which statement is true about this command?
9.
Routers R1 and R2 are configured for HSRP as shown below:
Router R1:
interface ethernet 0
ip address 20.6.2.1 255.255.255.0
standby 35 ip 20.6.2.21
standby 35 priority 100
interface ethernet 1
ip address 20.6.1.1.2 255.255.255.0
standby 34 ip 20.6.1.21
Router R2:
interface ethernet 0
ip address 20.6.2.2 255.255.255.0
standby 35 ip 20.6.2.21
interface ethernet 1
ip address 20.6.1.1.1 255.255.255.0
standby 34 ip 20.6.1.21
standby 34 priority 100
You have configured the routers R1 & R2 with HSRP. While debugging router R2 you notice very frequent HSRP group state transitions. What is the most likely cause of this?
10.
Which describes the default load balancing scheme used by the Gateway Load Balancing Protocol (GLBP)?