×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
You administer the network shown above. You issue the show interfaces trunk command on SwitchA and receive the following output:
Which of the following statements is true regarding VLAN 32?
Which of the following statements is true regarding VLAN 32?
2.
Which configuration option will cause the link between two Cisco 3600 Series Multiservice Platforms to become a functional trunk?
3.
If you were to set up a VLAN trunk over a Fast Ethernet link on switch R1, which trunk mode would you set the local port to on R1 if you wanted it to respond to requests from its link partner (R2) and become a trunk?
4.
You need to configure a new Company switch to support DTP. Which DTP switchport mode parameter sets the switch port to actively send and respond to DTP negotiation frames?
5.
Company uses MSTP within their switched LAN. What is the main purpose of Multiple Instance Spanning Tree Protocol (MSTP)?
6.
Which of the following specifications will allow you to associate VLAN groups to STP instances so you can provide multiple forwarding paths for data traffic and enable load balancing?
7.
Which set of statements about Spanning Tree Protocol default timers is true?
8.
Which statement is correct about RSTP port roles?
9.
How are STP timers and state transitions affected when a topology change occurs in an STP environment?
10.
What is the result of entering the command spanning-tree loopguard default?