×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
Why would you use the fcanalyzer command?
2.
What is the recommended minimum clearance between chassis when installing the Cisco MDS 9500 Series in a standard telco rack?
3.
Your company is planning a SAN deployment using Fibre Channel connections from a central, highly secure data center to several less secure branch offices. Which of these security features would allow you to disable all branch office switch management ports and yet still maintain the complete suite of TCP/IP-based SAN management utilities?
4.
What information does the command showflogi database provide?
5.
You have set up a session to the SD_Portto enable the investigation of a problem on a particular Fibre Channel port. You need to check whether this has been correctly set up for the desired port. Which command should you use?
6.
Which feature detects hardware faults and attempts recovery actions?
7.
You are implementing an FCIP solution for SAN extension between two data centers using the Cisco MDS 9000 Series platform. For redundancy, there are two Metro Ethernet paths between the data centers. How can you specify primary and secondary paths for each FCIP tunnel?
8.
What are four valid protocols for copying software to the MDS 9000 family switches? (Choose
four.)
9.
On a Class C IP network, how many bits in the IPv4 address are used to identify the network?
10.
After performing the initial switch configuration by running the setup utility, an administrator notices that ports configured to connect to other Cisco MDS 9000 switches invariably come up as E_Ports rather than TE_Ports. Which error was made at initial configuration?