×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
Which statement is correct about 802.1Q trunking?
2.
Which switch command enables a trunking protocol that appends a four byte CRC to the packet?
3.
While using a packet analyzer, you notice four additional bytes being added to the packets in the Company network. Which protocol inserts a four byte tag into the Ethernet frame and recalculates CRC value?
4.
Which statement is correct about 802.1Q trunking?
5.
Which command alone will disable trunking on a Layer 2 switch port?
6.
If you needed to transport traffic coming from multiple VLANs (connected between switches), and your CTO was insistent on using an open standard, which protocol would you use?
7.
The Company core switches use 802.1Q trunks to connect to each other. How does 802.1Q trunking keep track of multiple VLANs?
8.
You are the network administrator tasked with designing a switching solution for the Company network. Which of the following statements describing trunk links are
INCORRECT? (Choose four)
9.
You are the network administrator at Company and switch R1 is configured as shown below:
interface GigabitEthernet0/1
switchport mode trunk
switchport trunk encapsulation dot1q
switchport trunk native vlan 5
If untagged frames are arriving on interface GigabitEthernet0/1 of R1, which of the following statement are correct?
interface GigabitEthernet0/1
switchport mode trunk
switchport trunk encapsulation dot1q
switchport trunk native vlan 5
If untagged frames are arriving on interface GigabitEthernet0/1 of R1, which of the following statement are correct?
10.
What is the effect of applying the "switchport trunk encapsulation dot1q" command to a port on a Cisco Catalyst switch?