×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
Which Cisco IPS appliance CLI command is used to display information in the IPS Event Store?
2.
When using the Cisco IPS signature and engine auto updates feature from Cisco.com, which password must be configured on the IDM Auto/Cisco.com Update pane?
3.
Which rating is determined by adjusting the risk rating with respect to preventative actions taken by the sensor?
4.
Passive operating system fingerprinting can be used to determine which aspect of the event risk rating?
5.
What is the maximum number of virtual sensors that can be configured on a Cisco IPS 4260 Sensor appliance?
6.
Which Cisco IPS appliance feature has the following three potential settings: off, partial, and full?
7.
Defining the internal zone, external zone, and illegal zone is associated with which Cisco IPS appliance feature?
8.
Which protocol or protocols does the Cisco Security Manager use to communicate with the Cisco IPS appliance?
9.
Which Cisco IPS signature parameter can be tuned to reduce the volume of the alerts that are written to the event store?
10.
Which IPS appliance inline deployment mode should be used to support the following requirements?
- The IPS appliance will be installed in inline mode, on a dot1q trunk.
- VLANs 10, 20, 30, 40, and 50 exist on the dot1q trunk.
- Requirement is to inspect all VLANs except VLAN 50 with the IPS appliance.
- The IPS appliance will be installed in inline mode, on a dot1q trunk.
- VLANs 10, 20, 30, 40, and 50 exist on the dot1q trunk.
- Requirement is to inspect all VLANs except VLAN 50 with the IPS appliance.