1.
Which statement describes what happens if all VSL connections between the virtual switch members are lost?
2.
Which statement is correct about 802.1Q trunking?
3.
Which of the following commands can be issued without interfering with the operation of loop guard?
4.
The following command was issued on a router that is being configured as the active HSRP router.
standby ip 10.2.1.1
Which statement is true about this command?
5.
Routers R1 and R2 are configured for HSRP as shown below:
Router R1:
interface ethernet 0
ip address 20.6.2.1 255.255.255.0
standby 35 ip 20.6.2.21
standby 35 priority 100
interface ethernet 1
ip address 20.6.1.1.2 255.255.255.0
standby 34 ip 20.6.1.21
Router R2:
interface ethernet 0
ip address 20.6.2.2 255.255.255.0
standby 35 ip 20.6.2.21
interface ethernet 1
ip address 20.6.1.1.1 255.255.255.0
standby 34 ip 20.6.1.21
standby 34 priority 100
You have configured the routers R1 & R2 with HSRP. While debugging router R2 you notice very frequent HSRP group state transitions. What is the most likely cause of this?
6.
Which describes the default load balancing scheme used by the Gateway Load Balancing Protocol (GLBP)?
7.
To provide security, a service provider configures various private VLANs in its backbone network infrastructure to prevent certain VLANs from communicating to each other. Which version of VTP supports the use of private VLANs?
8.
Which statement about HSRP, GLBP, and VRRP is true?
9.
What action should a network administrator take to enable VTP pruning on an entire management domain?
10.
What is the effect of configuring the following command on a switch?
Switch(config) # spanning-tree portfast bpdufilter default