×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
What are four valid protocols for copying software to the MDS 9000 family switches? (Choose
four.)
2.
On a Class C IP network, how many bits in the IPv4 address are used to identify the network?
3.
After performing the initial switch configuration by running the setup utility, an administrator notices that ports configured to connect to other Cisco MDS 9000 switches invariably come up as E_Ports rather than TE_Ports. Which error was made at initial configuration?
4.
Which second-generation Fibre Channel module offers a full 4Gb/s line rate on all ports? Select the best response.
5.
Which Cisco MDS 9000 Series Switch has non-field-replaceable fans? Select the best response
6.
When using the Cisco MDS 9000 Switches, which protocol provides in-band management? Select the best response.
7.
What is a benefit of using the Cisco Fabric Manager Software Install Wizard instead of using the CLI-based software upgrade? Select the best response.
8.
A junior SAN engineer is asked to prepare the configuration for the NPV edge switch. The NPV edge switch will be connected to the NPV core switch via the fc 1/24 interface. The end device will be connected to the fc 1/1 interface and should be placed in VSAN 10. Which configuration for the NPV edge switch accomplishes this request? Select the best response.
9.
When looking at the Cisco Fabric Manager, you notice that one of the switches has this symbol superimposed on it. What is the reason? Select the best response.
10.
Which command can be used to determine whether device aliases in VSAN 5 are configured for fabric-wide distribution?