Citrix-Administration for Citrix XenApp 6 Set 1

Which option is used as a loop prevention mechanism to support MPLS VPN customers with multihomed sites?

Which CE-to-PE routing protocol implements the down bit as a loop prevention mechanism?

When you are using OSPF as the CE-to-PE routing protocol in MPLS VPN implementations, an OSPF route from customerA site 1 in Area 0 will appear as which kind of OSPF route in customerA site 2, also in Area 0?

In Layer 3 MPLS VPN implementations, if some of the VPNv4 routes on one PE router do not appear on another PE router, what could be the problem?

The Cisco IOS XR address-family ipv4 labeled-unicast and the Cisco IOS/IOS XE neighbor send- label commands are used in which MPLS implementation?

When verifying Layer 3 MPLS VPN operations, which Cisco IOS XR show command is best used to verify that the PE router is receiving the routes from the CE router?

When implementing Layer 3 MPLS VPNs on Cisco IOS/IOS XE PE routers, which PE-to-CE routing protocol requires a separate routing process to be created for each VRF?

In Layer 3 MPLS VPN implementations, if a customer is using the same AS number at both customer sites and the PE-to-CE routing protocol is BGP, what must be enabled on the PE router?

Which BGP extended community is used to control the distribution of VPN routing information and to identify routers that may receive a set of routes that carry the community?

In which configuration mode is a route distinguisher configured in a Cisco IOS XR router?