×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
What is required on a Cisco IOS XR router to assign an interface to a VRF?
2.
When implementing VPLS on Cisco IOS XR routers, the VPLS PW neighbors can be statically defined under which configuration mode?
3.
On Cisco IOS XR platforms using the EVC infrastructure, which command is used to enable a Layer 2 VPN subinterface?
4.
In Layer 3 MPLS VPN implementations, which protocol is used to carry the VPNv4 routes from PE to PE?
5.
What happens if the destination MAC address is not present in the table for the packets that are received on one of the ACs in VPLS?
6.
What type of routing is used between CE7 and PE7?
7.
In MPLS Layer 3 VPN implementations, which mechanism is used to control which routes are imported to a VRF?
8.
Which Cisco IOS XR BGP configuration command is required to enable MP-BGP to carry IPv6 VPN routes?
9.
When implementing MPLS Layer 3 VPNs with customers running OSPF as the CE-PE routing protocol, the service provider MPLS backbone looks like what to the CE routers?
10.
When implementing MPLS Layer 3 VPNs with customers running OSPF as the CE-PE routing protocol, which situation will require a sham link to be implemented in the MPLS backbone?