Cisco NM Network Management Set 3

The Cisco IOS XR address-family ipv4 labeled-unicast and the Cisco IOS/IOS XE neighbor send- label commands are used in which MPLS implementation?

When verifying Layer 3 MPLS VPN operations, which Cisco IOS XR show command is best used to verify that the PE router is receiving the routes from the CE router?

When implementing Layer 3 MPLS VPNs on Cisco IOS/IOS XE PE routers, which PE-to-CE routing protocol requires a separate routing process to be created for each VRF?

In Layer 3 MPLS VPN implementations, if a customer is using the same AS number at both customer sites and the PE-to-CE routing protocol is BGP, what must be enabled on the PE router?

Which BGP extended community is used to control the distribution of VPN routing information and to identify routers that may receive a set of routes that carry the community?

In which configuration mode is a route distinguisher configured in a Cisco IOS XR router?

Which Layer 2 VPN technology is implemented over an IP core network without the need for MPLS?

When implementing EoMPLS on Cisco IOS XR routers, which command under the l2vpn configuration mode is used to define the pseudowire?

When implementing EoMPLS PWs, which configuration is optional?

Which command would you use to determine if device aliases in VSAN 5 are configured for fabriC.wide distribution?