Cisco MPLS Implementing Cisco MPLS Set 2

1.

Which EAP method uses a modified version of the MS-CHAP authentication protocol?

CEF is enabled by default on all Cisco routers. CEF's default operation are router dependent. CEF is disabled by default on all Cisco routers. CEF is enabled at a global level, but is disabled at an interface level.

2.

Under which circumstance would an inline posture node be deployed?

MPLS inserts a 32-bit label after the Layer 3 header. MPLS replaces the Layer 2 header with a 32-bit label. MPLS replaces the Layer3 header with a 32-bit label. MPLS inserts 32-bit label between the Layer 2 and Layer 3 headers.

3.

Which Cisco ISE 1.x protocol can be used to control admin access to network access devices?

Enable MPLS at a global level. Enable tag-switching at the global level. Enable MPLS switching on the affected interfaces. Enable Cisco Express Forwarding (CEF) at the global and affected interfaces.

4.

A user is on a wired connection and the posture status is noncompliant. Which state will their EPS session be placed in?

MPLS frames are sent over a reserved session. MPLS is identified in the protocol port of the Layer 3 header. MPLS frames are sent in a special frame with a multicast address similar to CDP. The Ether Type of PID in the Layer 2 header identifies the frame as an MPLS frame.

5.

In Cisco ISE, which probe must be enabled to collect profiling data using Device Sensor?

pvc auto tag-switching ip ip unnumbered loopback 0 interface atm 0/0.2 point-to-point

6.

Which statement about Cisco ISE BYOD is true?

In large ATM-MPLS networks, the LFIB can become too large. Because of this, it is necessary to limit the
maximum diameter of the MPLS network. TDP relies exclusively on hop-count carried in the TDP request and replay packets to detect loops duringthe downstream-on-demand label allocation. LDP does not support using Router ID to detect routing information in ATM networks during thedownstream-on demand label allocation process. Because end-to-end delay can cause problems with some voice applications, it is necessary to limit themaximum diameter of the MPLS network.

7.

Which protocol sends authentication and accounting in different requests?

It indicates that the VC merge capability has been successfully negotiated. It indicates a set of options that both LDP peer devices have agreed to share on this interface. It indicates that both TDP peer devices have completed the negotiation phase and have agreed on the TDP/LDP distribution. It indicates that the negotiated allocation scheme is UNDIR, if and only if, both peer devices have UNIDIRcapability (otherwise it is BIDIR).

8.

You enabled the guest session limit feature on the Cisco ISE. However, end users report that the same guest can log in from multiple devices simultaneously. Which configuration is missing on the network access device?

The VPI/VCI must be manually assigned using a value from the label pool. The VCI/VPI are assigned dynamically by LDP using a value from the label pool. The VPI/VCI must be manually assigned using a value supported by the local ATM switch. The interface automatically learns the VPI/VCI from the local ATM switch and associates it with the definedMPLS.

9.

A properly configured Cisco ISE Policy Service node is not receiving any profile data from a Cisco switch that runs Device Sensor. Which option is the most likely reason for the failure?

LDP sessions are established over a reserved PVC. The attached ATM switch is aware of the MPLS traffic. A TDP or LDP neighborship is established between the two PVC endpoint routers. Switching is performed based on the VPI/VCI value in the ATM header established by LDP.

10.

A network administrator needs to implement a service that enables granular control of IOS commands that can be executed. Which AAA authentication method should be selected?

Designed to establish switch-to-switch connectivity between parts of a public ATM network over a private
network. Designed to establish switch-to-switch connectivity between parts of a private ATM network over a publicnetwork. Designed to establish router-to-router connectivity between parts of a private ATM network over a publicnetwork. Designed to establish router-to-router connectivity between parts of a public ATM network over a privatenetwork.

Cisco MPLS Implementing Cisco MPLS Set 2

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Congratulations

COMPANY

Products

OTHERS

Partner

Cisco MPLS Implementing Cisco MPLS Set 2

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Congratulations

Detail Form

COMPANY

Products

OTHERS

Partner