Cisco Interconnecting Cisco Networking Devices Part 1 Set 2

the command syntax is incorrect ✘ the interface type does not exist on this router ✘ the command is entered at the wrong prompt ✘ the interface is configured already ✔

switch(config)# vtp domain MARKETING 25

✘

switch(config)# vlan 25switch(config-vlan)# name MARKETING

✘

switch(config-if)# vlan 25 name MARKETING

✘

switch(config)# vtp 25switch(config-vtp)# name MARKETING

✔

set port-security ✘ switchport port-security ✘ set port-security enable ✘ switchport port-security enable ✔

0.0.0.7 ✘ 0.0.0.15 ✘ 0.0.0.31 ✘ 0.0.0.63E 0.0.31.255 ✔

There are four default routes on this router. There are four physically connected interfaces on this router. This router is running EIGRP. The metric for the routes learned via a routing protocol is 90. A packet for the 192.168.52.0 network will be load-balanced across two paths.

E-mail ✘ FTP ✘ Web browser ✘ Telnet ✔

RJ-45 straight-through ✘ RJ-41 crossover ✘ RJ-11 straight-through ✘ RJ-45 crossover ✔

Fa0/1 ✘ Fa0/2 ✘ Fa0/3 ✘ Fa0/5 ✔

description ✘ banner motd ✘ hostname ✘ banner exec ✔

R1(config)#int S1R1(config-if)#no ip address 192.168.5.5R1(config-if)# ip address 192.168.5.9 255.255.255.252

✘

R1(config)#no ip host R1R1(config)# ip host R2 192.168.5.6 255.255.255.252

✘

R1(config)#no hostname R2R1(config)# hostname R1

✘

R2(config)#int S1R1(config-if)#no ip address 192.168.5.5R1(config-if)# ip address 192.168.5.9 255.255.255.0

✔