×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
When configuring port security on a Cisco Catalyst switch port, what is the default action taken by the switch if a violation occurs?
2.
You are responsible for increasing the security within the Company LAN. Of the following choices listed below, which is true regarding layer 2 security and mitigation techniques?
3.
Given the configuration on a switch interface, what happens when a host with the MAC address of 0003.0003.0003 is directly connected to the switch port?
switchport mode access
switchport port-security
switchport port-security maximum 2
switchport port-security mac-address 0002.0002.0002
switchport port-security violation shutdown
switchport mode access
switchport port-security
switchport port-security maximum 2
switchport port-security mac-address 0002.0002.0002
switchport port-security violation shutdown
4.
When you enable port security on an interface that is also configured with a voice VLAN, what is the maximum number of secure MAC addresses that should be set on the port?
5.
When configuring private VLANs, which configuration task must you do first?
6.
A switch has been configured with Private VLANs. With that type of PVLAN port should the default gateway be configured?
7.
What is the result of entering the command "port-channel load-balance src-dst-ip" on an EtherChannel link?
8.
Which statement is true regarding the Port Aggregation Protocol?
9.
Which statement best describes implementing a Layer 3 EtherChannel?
10.
Assume that a host sends a packet to a destination IP address and that the CEF-based switch does not yet have a valid MAC address for the destination. How is the ARP entry (MAC address) of the next-hop destination in the FIB get?