×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
If you were to set up a VLAN trunk over a Fast Ethernet link on switch R1, which trunk mode would you set the local port to on R1 if you wanted it to respond to requests from its link partner (R2) and become a trunk?
2.
You need to configure a new Company switch to support DTP. Which DTP switchport mode parameter sets the switch port to actively send and respond to DTP negotiation frames?
3.
Company uses MSTP within their switched LAN. What is the main purpose of Multiple Instance Spanning Tree Protocol (MSTP)?
4.
Which of the following specifications will allow you to associate VLAN groups to STP instances so you can provide multiple forwarding paths for data traffic and enable load balancing?
5.
Which set of statements about Spanning Tree Protocol default timers is true?
6.
Which statement is correct about RSTP port roles?
7.
How are STP timers and state transitions affected when a topology change occurs in an STP environment?
8.
What is the result of entering the command spanning-tree loopguard default?
9.
Examine the diagram. A network administrator has recently installed the above switched network using 3550s and would like to control the selection of the root bridge. Which switch should the administrator configure as the root bridge and which configuration command must the administrator enter to accomplish this?
10.
What must be the same to make multiple switches part of the same Multiple Spanning Tree (MST)?