Cisco Implementing Cisco Switched Networks Set 1

Which command alone will disable trunking on a Layer 2 switch port?

If you needed to transport traffic coming from multiple VLANs (connected between switches), and your CTO was insistent on using an open standard, which protocol would you use?

The Company core switches use 802.1Q trunks to connect to each other. How does 802.1Q trunking keep track of multiple VLANs?

You are the network administrator tasked with designing a switching solution for the Company network. Which of the following statements describing trunk links are INCORRECT? (Choose four)

You are the network administrator at Company and switch R1 is configured as shown below:
interface GigabitEthernet0/1
switchport mode trunk
switchport trunk encapsulation dot1q
switchport trunk native vlan 5
If untagged frames are arriving on interface GigabitEthernet0/1 of R1, which of the following statement are correct?

What is the effect of applying the "switchport trunk encapsulation dot1q" command to a port on a Cisco Catalyst switch?

Two Company switches are connected via a trunk link. In this network, the original frame is encapsulated and an additional header is added before the frame is carried over a trunk link. At the receiving end, the header is removed and the frame is forwarded to the assigned VLAN. This describes which technology?

You administer the network shown above. You issue the show interfaces trunk command on SwitchA and receive the following output:
Which of the following statements is true regarding VLAN 32?

Which configuration option will cause the link between two Cisco 3600 Series Multiservice Platforms to become a functional trunk?

If you were to set up a VLAN trunk over a Fast Ethernet link on switch R1, which trunk mode would you set the local port to on R1 if you wanted it to respond to requests from its link partner (R2) and become a trunk?