×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
An access switch has been configured with an EtherChannel port. After configuring SPAN to monitor this port, the network administrator notices that not all traffic is being replicated to the management server. What is a cause for this issue?
2.
A network engineer tries to configure storm control on an EtherChannel bundle. What is the result of the configuration?
3.
What is the function of NSF?
4.
After UDLD is implemented, a Network Administrator noticed that one port stops receiving UDLD packets. This port continues to reestablish until after eight failed retries. The port then transitions into the errdisable state. Which option describes what causes the port to go into the errdisable state?
5.
After reviewing UDLD status on switch ports, an engineer notices that the switch LEDs are green. Which statement describes what this indicates about the status of the port?
6.
Pilot testing of the new switching infrastructure finds that when the root port is lost, STP immediately replaces the root port with an alternative root port. Which spanning-tree technology is used to accomplish backup root port selection?
7.
A network engineer must set the load balance method on an existing port channel. Which action must be done to apply a new load balancing method?
8.
What does the command vlan dot1q tag native accomplish when configured under global configuration?
9.
A network engineer has just deployed a non-Cisco device in the network and wants to get information about it from a connected device. Cisco Discovery Protocol is not supported, so the open standard protocol must be configured. Which protocol does the network engineer configure on both devices to accomplish this?
10.
A manager tells the network engineer to permit only certain VLANs across a specific trunk interface. Which option can be configured to accomplish this?