Cisco-Implementing Cisco IP Routing Set 2

For the accompanying router output, which of the following statements describes the state that neighbor 172.16.254.3 is in? Select the best response.

Above is the output from show ip bgp neighbors command. What is line 21 stating about the BGP connection? Select the best response.

During a recent OSPF election among three routers, RTA was elected the DR and RTB was elected the BDR, as seen in the graphic. Assume that RTA fails, and that RTB takes the place of the DR while RTC becomes the new BDR. What will happen when RTA comes back online? Select the best response.

The Dev-1 and Dev-3 routers are OSPF neighbors over the Ethernet 0/0 connection. Based on the show ip ospf neighbor output from the Dev-1 and Dev-3 routers, which statement is true? Select the best response.

Refer to the diagram. Which OSPF configuration command is required to configure Area 3 as a totally stubby area? Select the best response.

The 192.168.0.0 network is not being propagated throughout the network. Observe the BGP configuration commands from the advertising router. What is the reason the 192.168.0.0 route is not being advertised? router bgp 65111 neighbor 172.16.1.1 remote-as 65111 neighbor 172.16.2.1 remote-as 65112 network 192.168.0.0 network 10.0.0.0 ! ip route 192.168.0.0 255.255.0.0 null0 Select the best response.

Which BGP path attribute is Cisco proprietary? Select the best response.

Which show command will display only the Type 5 LSAs in the OSPF topology database? Select the best response.

Which attribute must exist in the BGP update packet? Select the best response.

Observe the diagram. RTC is the hub router and RTA and RTB are the spokes. There are no virtual circuits between the spoke locations. What is needed to successfully route traffic to the 11.11.11.0/24 network from RTA? Select the best response.