Cisco Implementing Cisco IOS Unified Communications Advanced

1.

What is the best practice of configuring an intercom on a shared line?

This feature allows all endpoints to participate in intercom messages. This feature can be used only when the intercomephone-dn is configured as a dual line This feature is not supported and should not be used This feature can be supported only in a unidirectional manner. This feature allows one endpoint to contact multiple endpoints simultaneously

2.

Which command would you use to verify that IMAP integration is working?

show imap detail show imap sessions show imapprofile show ccn imap

3.

Your organization wants to provide systemwide call blocking to long distance and international numbers outside of normal business hours, even though there may be employees in the office. Which method allows this to be accomplished?

Assign a class of restriction to each ephonedn and each dial peer. Configure hours outside normal business hours and apply to each ephonedn. Configure afterhours times and dialednumber ranges to block and apply though the after hours command. Configure afterhours times and dialednumber ranges to block.

4.

Which mode allows you to configure the B-ACDservice provided in Cisco Unified Communications Manager Express?

telephony application Tcl IP-telephony telephony service

5.

Which configuration snip creates anephone template that provides transfer to voice mail, allows calls to be transferred to the voice-mail pilot extension 1999, and uses four digits for each extension?

Certpaper4(config-ephone)# ephone-template 1Certpaper4(config-ephone-template)#softkeys seized Park

Hold Trnsfer TrnsVM ConfrnCertpaper4(config-telephony)# transfer-pattern 1999..blind

Certpaper4(config-ephone)# ephone-template 1Certpaper4(config-ephone-template)#softkeys connectedPark Hold Trnsfer TrnsVM ConfrnCertpaper4(config-telephony)# transfer-pattern 1999....blind

Certpaper4(config-ephone)# ephone-template 1Certpaper4(config-ephone-template)#softkeys connectedPark Hold Trnsfer TrnsVM ConfrnCertpaper4(config-telephony)# transfer-pattern 1999.... consult

Certpaper4(config-ephone)# ephone-template 1Certpaper4(config-ephone-template)#softkeys connectedPark Hold Trnsfer TrnsVM ConfrnCertpaper4(config-telephony)# transfer-pattern 1999..

Certpaper4(config-ephone)# ephone-template 1Certpaper4(config-ephone-template)#softkeys connectedPark Hold Trnsfer TrnsVM ConfrnCertpaper4(config-telephony)# transfer-pattern 1999....

6.

The Acme Rocket Corporation is integrating their existing Octel voice-mail system with Cisco Unified Communications Manager Express. The Octel voice-mail system has four ports and a voice -mail pilot point of 53222. How should the Cisco Unified Communications Manager Express be configured to support this integration?

A separate VoIP dial peer must be configured for the four pilot point numbers Fourephones and four dial peers must be configured with the same pilot point number Four dial peers must be configured with the same pilot point number Fourephone-dns and four ephones must be configured with the same pilot point number

7.

Your IP telephony manager wants you to configure an FXS port on a voice -enabled router with these requirements:
1) It supports ground- start signaling
2) Calling name is James Smith
3) Calling number is 408-555-1212
4) Ring frequency is 25hz
5) Ring cadence is for Germany
Which configuration will meet these requirements?

voice-port 1/0/0signal ground- start cp tone Dering frequency 25 station -id name James Smith station-id number 4085551212

voice-port 1/0/0signal ground- start cadence Germany frequency25station-id name James Smith station-idnumber 4085551212

voice-port 1/0/0description extension 555-1212, name "James Smith" signal ground- start ring cadenceDEringfrequency25

voice-port 1/0/0description extension 555-1212, name "James Smith" ring cadence Germanyringfrequency25station-id name James Smith station -id number 5551212

8.

Which configurations must be performed to enable IMAP integration for voice mail?

The IMAP service must been abled on Cisco Unity Express and a group name with privilege vm- imap must be configured on Cisco Unity Express The IMAP service must beenabled on Cisco Unity Express and Cisco Unified Communications ManagerExpress and a group name with privilege vm-imap must be configured on Cisco Unity Express The IMAP service must been abled on the Cisco Unified Communications Manager Express and a groupname with privilege vm-imap must be configured on Cisco Unity Express The IMAP service must been abled on Cisco Unified Communications Manager Express and a group namewith privilege vm-imap must be configured on Cisco Unified Communications Manager Express. TheIMAP service must been abled on Cisco Unity Express and a group name with privilege vm- imap mustbe configured on Cisco Unified Communications Manager Express

Cisco Implementing Cisco IOS Unified Communications Advanced

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Congratulations

COMPANY

Products

OTHERS

Partner

Cisco Implementing Cisco IOS Unified Communications Advanced

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Answer & Solution

Answer: Option B

Solution:

Congratulations

Detail Form

COMPANY

Products

OTHERS

Partner