×
Detail Form
We will send your result on your email id and phone no. please fill detail
1.
You executed the following commands to assign an IPv6 link-local address to the Fa0/0 interface of the R1 router:
R1(config)# interface Fa0/0
R1(config-if)# ipv6 ospf 1 area 1
When you executed the show running-config command on the R1 router, you observed that OSPF for IPv6 is not running on the router. Which of the following commands should be added to the interface configuration?
R1(config-if)# ipv6 ospf 1 area 1
2.
Consider the following diagram. All PVCs are active. If the partial output of the show ip ospf neighbor command executed on Router A is as follows, which of the following statements is TRUE?
RouterA# show ip ospf neighbor
Neighbor ID Pri State Dead Time Address Interface
1.1.1.1 1 FULL/DROTHER 00:00:13 10.20.10.21 SerialO
2.2.2.2 1 FULL/DR 00:00:51 10.20.10.22 SerialO
Neighbor ID Pri State Dead Time Address Interface
1.1.1.1 1 FULL/DROTHER 00:00:13 10.20.10.21 SerialO
2.2.2.2 1 FULL/DR 00:00:51 10.20.10.22 SerialO
3.
When configuring a DMVPN solution, which of the following technologies makes it possible for the spoke routers to use dynamic IP addressing?
4.
You are planning the configuration of Easy Virtual Networking (EVN). Which of the following statements is true of an interface that will be an EVN trunk?
5.
After an associate configured a DMVPN hub, you execute the following command on the hub router: Which of the following statements is true of this output?
6.
Examine the following output of the show ip route command and the partial output of the show run command from the router R63:
What will the router do with a packet with a source address of 192.168.5.5/24 and a destination address of 10.11.11.20/ 24 that arrives on the Serial0/0 interface?
What will the router do with a packet with a source address of 192.168.5.5/24 and a destination address of 10.11.11.20/ 24 that arrives on the Serial0/0 interface?
7.
Earlier today you created and applied an access list designed to restrict remote access to the router R62 ONLY from the device at 2001:DB8:0:4:: 32. During testing, you discover that it is not having the desired effect. You execute the show run command and see the following partial output that is relevant to the issue: Why is the access list not functioning correctly?
8.
Which of the following commands must be present in the configuration to support Unicast RFP?
9.
When the auth keyword is used in the snmp-server host command, which of the flowing must be configured with an authentication mechanism?
10.
You recently implemented SNMPv3 to increase the security of your network management system. A partial output of the show run command displays the following output that relates to SNMP.